Măsurarea piesei: TS 248/TS 260 - HEIDENHAIN

Specifications

	Cable
Workpiece touch probe	TS 248 TS 260	TS 150
Probe accuracy	≤ ±5 µm with use of the T404 standard stylus
Probe repeatability Repeated probing from one direction	2 s ≤ 1 µm at a probing velocity of 1 m/min Typical values: 2 s ≤ 1 µm at a probing velocity of 3 m/min 2 s ≤ 4 µm at a probing velocity of 5 m/min
Deflection of probe contact	≤ 5 mm in all directions (with stylus length L = 40 mm)
Deflection forces	Axial: 8 N (TS 248: 4 N) Radial: 1 N (TS 248: 0.5 N)
Probing velocity	≤ 5 m/min
Protection EN 60529	IP68
Operating temperature	10 °C to 40 °C
Storage temperature	–20 °C to 70 °C
Mass without taper shank	0.15 kg	0.1 kg
Fastening*	• With taper shank1) (only with radial flange socket) • Via M28x0.75 external thread • Via coupling joint with M22x1 external thread	• Via M16x1 external thread on the mounting base • Contact on the mounting base • Axial cable outlet: M22x1 for fastening to the machine • Radial cable outlet: Fastened to the machine with four M3 screws
Electrical connection*	8-pin M12 flange socket, axial or radial	Two-pole sliding contact on the mounting base
Cable length	≤ 25 m
Supply voltage2)	DC 15 V to 30 V/≤ 100 mA (without load)	DC 15 V to 30 V/≤ 85 mA (without load)
Output signals2)	• Trigger signals S and S (square-wave signal and its inverted signal) • Floating trigger output
HTL signal levels2)	UH ≥ 20 V at –IH ≤ 20 mA UL ≤ 2.8 V at IL ≤ 20 mA at rated voltage of DC 24 V
Signal transmission	Cable
* Please select when ordering 1) See Mounting on page 18 2) With the TS 150: over the UTI 150